sdirectvasup.blogg.se

1. MIMAKI CG 60ST CUTTING PLOTTER DRIVER INSTALL
2. MIMAKI CG 60ST CUTTING PLOTTER DRIVER DRIVER
3. MIMAKI CG 60ST CUTTING PLOTTER DRIVER SOFTWARE
4. MIMAKI CG 60ST CUTTING PLOTTER DRIVER PC

1) Data jam due to noise in the cable (not recurrent).

MIMAKI CG 60ST CUTTING PLOTTER DRIVER SOFTWARE

If “OEM” appears instead of “CG” upon power on, turn power again while holding DATA CLEAR and FUNCTION keys down and reset all bits of software DIP switch setting to 0.Ĭuts normally but the error message appears although very rarely. Consult the application provider if a more recent version or a substitutable application (HP-GL or graphic command compatible) is available. If application output model selection is available, select CG-FX or other Mimaki model (EX, LX, ST, etc) and check.

MIMAKI CG 60ST CUTTING PLOTTER DRIVER INSTALL

If the application allows use of a Mimaki plotter driver, install the driver.

MIMAKI CG 60ST CUTTING PLOTTER DRIVER DRIVER

The application or the plotter driver does not match the CG-FX command. If the command type is not recognized automatically in AUTO, identify the command type with the data monitor or the dump function. If the command type is unknown, receive the command in AUTO to identify the command type. If both MGL_1c1 and MGL_11c are selectable, choose MGL_11c so that the mark detect function is available.

MIMAKI CG 60ST CUTTING PLOTTER DRIVER PC

Check the output command with the host PC application or the plotter driver and match the plotter command type to that of the host PC. Analyze the command using a data monitor.Ĭommand type setting error. Check communication protocol of the host PC and set the plotter setting to that of the host PC.

Replace the flash ROM or the main PCB assembly. Phenomena 1 through 4 above occur and the program is recovered but the trouble recurs frequently. Suspect malfunction of the flash ROM if RAM is normal. No action is needed if the program starts and works normally. An error results on write data check when storing parameters. This message appears and the operation freezes. Otherwise, check pen pressure, landing, mechanical compensation, right angle compensation, cutting position adjustment, photo sensor position adjustment, and sensor offset. 5) If the recorded parameters are not normal, re-write the saved parameters. 4) If the recorded parameters are normal, set these parameters. Do the following if “RECOVER FAILURE” appears: 1) Turn power on while holding or key down to activate system parameter setting mode. Check parameters and set parameters as needed if a problem occurs in initial state.

No action is needed if the program restarts normally. An error resulted on hash check and the program is waiting for recovery operation with backup data. This message appears momentarily and “RECOVER = ENTER key” appears. Set parameters as needed if a problem occurs in initial state. No action is needed if check results are normal. Check set parameters, pen parameters, communication parameters, sensor offset, and system parameters.

An error resulted on hash check but was corrected after the parameter was initialized. This message appears momentarily and starts normally after “PRMchk NG RETRY!” appears. An error resulted on hash check but was corrected automatically with backup data.